136. Electronic ignitor

Entry:2020.04.30 / Work:2020.04.29

I replaced the distributor points with electronic igniters.
(PerTronix 1847V Ignitor Bosch 4 cyl Vacuum)
I have set up both the MSD6AL and this igniter on my BUS.

PS: After that, during a long-distance trip around in the latter half of October, I had a symptom of intermittent misfire without any warning.　Also, when I returned to and ran in the neighborhood, I sometimes had symptoms.　After returning to the point formula, no symptoms have occurred.　I didn't feel the difference in performance so much, and it's better to be able to run with peace of mind.

Making process

Set and check operation. It looks okay. The coil on the upper left is used with the MSD.

However, it doesn't look good. It's temporary.

Since this is a spare coil, use only the negative terminal, and connect the positive side independently.

Multiple wires come together, so two general unidirectional flat terminals are docked to the male flat terminal 3-branch type.

Remove the points and condenser from the distributor.

Here is the package and contents.

E:2020.09.08 / W:2020.04.12

E:2020.03.15 / W:2020.02.29

E:2020.01.13 / W:2020.01.12

E:2020.08.30 / W:2019.12.16←15

E:2020.08.29 / W:2019.11.12

E:2020.01.07 / W:2019.11.02←2015.12.29

E:2020.08.27 / W:2019.10.06

E:2020.01.06 / W:2019.09.21

E:2020.01.05 / W:2019.09.01

- END -