The body was beautiful, but the louver window was oxidized and white rust was generating, so I restored it. I also cleaned the screen door. All rubber moldings were replaced with new ones, and UV-cut insulation film was applied to the glass.
The inside that you can see when you open it is also beautiful and feels good!
Installed. This was actually quite difficult to install.
I polished the outer circumference before installing the louver window.
Attach the assembled flap glass to the outer frame.
Attach a frame to the glass with the film attached.
Next, apply a UV cut insulation form to the glass.
After polishing the frame, stretch the net and fix it.
Original state on the left. It's not that bad, but when you polish it, it shines!
Next, remove the net from the screen door and polish the frame.
When you polish it, it becomes beautiful, so as a result, you end up polishing everything.
Also polish the linkage parts other than the frame.
Fix it to the table with a clamp and polish the surface.
I feel like I'm chasing too much, but I can't back down.
I disassembled it to polish the inside of the outer frame.
Place it on the table and clean it with a wire brush.
The outside is pretty dirty.
From the top, the polished frame, the frame as it is, and the outer frame.
I removed the frame from the glass and tried polishing it. become beautiful.