« VW Type-2 LateBay BUS
128. Brake servo install
E:2020.01.06 / W:2019.09.21
127. Spot cooler install 2
Entry:2020.01.05 / Work:2019.09.01
To further enhance the cooling effect, I thought about putting the main unit in front of the BUS and putting only cold air into the room through the fresh air intake. But I gave it up. Because it was too big and too heavy !!
The next idea is to install a suction duct to take in cool air from the cooled anterior chamber and then reduce the heat generated by the unit. As a result, the outside air temperature minus 2.6 ℃. Less effective than last time. (T_T)
It is thought that the intake resistance increased due to the provision of the duct, and that the unit became hot and the cooling efficiency decreased. So, I have given up installing a spot cooler on the BUS. (ToT)
126. Rear panel sheet
E:2019.10.02 / W:2019.08.14
125. DC-AC inverter and line auto selector
E:2020.01.03 / W:2019.08.11
124. Spot Cooler install 1st try
E:2020.08.26 / W:2019.08.10
123. Uchiyama farm camp site 2019
E:2020.08.25 / W:2019.07.14←13
122. Added push rod seal and pad
E:2019.12.12 / W:2019.07.06
121. Push pod & pin replacement
E:2019.12.11 / W:2019.07.05
120. Flash Bugs Meeting vol.36
E:2020.08.24 / W:2019.05.13
119. Bluetooth audio update
E:2019.12.08 / W:2019.03.31
118. Grease up the front axle beam
E:2019.12.03 / W:2019.03.24
- END -