85. Sequential turn signal lights

When I compared it, it was better without the sticker, so I peeled it off and reassembled it.

Add caulking material around the lens.

Add more one unit in the middle. Each unit was installed in a stepped pattern.

Check lighting. It looks brighter than before.

I decided to remount it facing outwards to make it brighter. I thought that the blinker part would be dark if left as it was, so I put a reflective seal sheet on the surface.

But it wasn't very bright, so I added another one below. There was also an idea to be able to use it even with standard light bulbs attached.

This is the first specification. I thought it would be better if the light source could not be seen directly, so I put it downwards.