« VW Type-2 LateBay BUS
135. License plate line
134. Decoration line to a BUS body
I designed a decoration line for my friend's BUS. And we putted the line sticker on the BUS together. I putted white border lines, Diamond patterns, and text on top of the black baseline. (^_^)
Complete.
I will put a diamond mark on the sliding door.
Check the position to connect the diamond mark to the sliding door.
Paste the text in front of the baseline.
80% done...
This part is too three-dimensional, so I put a line only on the flat part.
The sliding door handle part is one step down, so divide the line.
A line was connected from the left side to the rear.
Decorative lines neatly fit into the corners of the body.
Don't make it suddenly, check the shape only with the base seal.
Correct the corner seal to the curve according to the car body shape.
Due to the downward widening of the corners, the straight seal deviates from the body line.
The owner did the pasting on the vehicle.
Paste the guide tape so that the decoration sticker can be applied neatly.
The decoration line seal is completed.
Paste the diamond marks at equal intervals.
Parts other than the straight line at the tip were made with separate parts.
Cut out the base black sticker and paste the white line sticker there.
Divide it according to the panel size at the position where the line is inserted.
First of all, I will make a design proposal on the computer and compare it.